I'm configuring a new installation of Mylar on a Qnap NAS TS-451A running QTS 4.3.3
When I go to the web gui, it's on port 48090, but I want to change it to port 8484
So I go to Settings->Web Interface->HTTP Port
and set it to 8484 and Save Changes, But it doesn't take.
I tried restarting Mylar and rebooting the NAS.
Yet, when I load the Web Interface, the port is shown as 8484 (Mylar saves the desired port). But Mylar still loads at
http://192.168.1.110:48090, not at
http://192.168.1.110:8484 (nothing loads at 8484)
this is in my config.ini:
Code: Select all
cv_verify = 1
http_port = 8484
http_host = 0.0.0.0
http_username = ""
http_password = ""
http_root = /